When the winter rain sets in across Victoria, water has a way of finding the lowest point on your property and sitting there in a sump, a stormwater pit, a flooded cellar or a low corner of the yard. A good submersible pump is the quickest way to clear out the water and protect your property. The Bianco Pumpz VAS2 has range of submersible pump options, this guide breaks it down so you can land on the right pump.

But what is a submersible pump exactly? Simply, it is a pump that sits fully underwater and pushes water up and out.

What do you use one for?

  • Clearing flooded sumps and stormwater pits
  • Dewatering cellars, basements and garages
  • Emptying drainage pits and catch basins
  • Clearing greywater and light slurry from ditches, ponds and drains
  • Transferring water out of tanks and troughs

Bianco Submersible pump comparison guide

Model Best For Max Head Max Flow Solids Power Float Type Outlet
Bianco BIA-B18VAS2 submersible vortex pump BIA-B18VAS2 General drainage, sumps, cellars 7 m 133 L/min 15 mm 180 W Cable (tethered) 1¼" BSPF
Bianco BIA-B18VAS2-FF submersible vortex pump with fixed float BIA-B18VAS2-FF Small or shallow pits, greywater 7 m 133 L/min 15 mm 180 W Fixed vertical 1¼" BSPF
Bianco BIA-B45VAS2 submersible vortex pump BIA-B45VAS2 Larger domestic, light commercial 8.5 m 200 L/min 25 mm 450 W Cable (tethered) 2" BSPF
Bianco BIA-B45VAS2-FF submersible vortex pump with fixed float BIA-B45VAS2-FF Mid-size jobs, tight or shallow pits 8.5 m 200 L/min 25 mm 450 W Fixed vertical 2" BSPF
Bianco BIA-B75VAS2 submersible vortex pump BIA-B75VAS2 High-volume drainage, larger pits 10 m 300 L/min 25 mm 750 W Cable (tethered) 2" BSPF
Bianco BIA-B75VAS2-FF submersible vortex pump with fixed float BIA-B75VAS2-FF High-volume, tight or shallow pits 10 m 300 L/min 25 mm 750 W Fixed vertical 2" BSPF

Do you need a cable float or fixed float?

BIA-B18VAS2 cable float in the off position
BIA-B18VAS2 cable float in the on position

Cable float

On the standard models, the float hangs from a length of cable and swings upward as the water rises, switching the pump on. As the water drops, the float falls and switches the pump off.

Works best for:

  • Wider, deeper pits, sumps and tanks
BIA-B75VAS2-FF fixed float in the off position
BIA-B75VAS2-FF fixed float in the onposition

Fixed vertical float

On the FF models, the float is fixed vertically, and rises with the water switching the pump on. As the water drops, the float falls and switches the pump off.

Works best for:

  • Compact spaces and smaller/ shallow pits

The Bianco Pumpz VAS2 range at a glance

The Bianco VAS2 range is built for clean or slightly dirty water with soft solids (stormwater, drainage and greywater) and not raw sewage or heavy solids.

A few quick definitions for the table below:

  • Max head is how high (or far) the pump can push water — the greater the head, the higher the lift before flow drops away.
  • Max flow is how much water it shifts at its best, measured in litres per minute.
  • Solids is the largest soft particle the pump can pass without clogging.
  • Float every pump comes in two versions. Standard model with a cable float and an FF model with a fixed float.
Add a video link or connect a metafield

Need more information?

Give us a call or visit us in Pakenham or Yarragon VIC for expert advice to ensure you pick the right pump or filter system.

Mon-Fri: 7:30am-5pm AEDT